Owner’sManualMODEL: HSS-NG-SSIMPORTANTRead this manual carefully before assembling, using or servicing this heater. Keep this manual for future refere
9.Your heater was designed and approved for outdooruse only. Do NOT use it inside a building, garage, orany other enclosed area..Make sure surrounding
10If you experience any ignition problem pleaseconsult “Troubleshooting” on page 11.Caution: Avoid inhaling fumes emitted from theheater’s first use
11TroubleshootingIf the problem is: And this condition exists: Then do thisPilot won’t lightCylinder valve is closed Open valveBlockage in orifice or
12.Gas odor with extreme yellow tipping of flame..Heater does NOT reach the desired temperature..Heater glow is excessively uneven..Heater makes poppi
1ContentsGeneral Safety Information... 1Assembly InstructionsComponents & Hardware...
2DANGER• EXPLOSION - FIRE HAZARD• Keep solid combustibles, such as building materials,paper or cardboard, a safe distance away from the heateras recom
3WARNING• This product is fueled by propane gas. Propane gas isinvisible, odorless, and flammable. An odorant is normallyadded to help detect leaks an
4HardwarePicture Qty DescriptionUsed inStep(s)4Medium Bolt 29 Small Screw 69Large FlatWasher4 & 79Small FlatWasher64Large Flange4 Req’d LargeFlang
5Step 3 – Attach Post to PostAttach lower post and upper post to the each end ofmiddle post.Using 4 screws to fasten them.Fully tighten all of the scr
6.Load Head Assembly by inserting hose into post..Insert Head Assembly into post..Control knob should be above decal on post..Attach Head Assembly to
7Step 7 – Attach Reflector Assembly to Studs.Support Heater..Slide 3 Large Flat Washers over threaded end ofStuds..Locate Reflector Assembly on 3 stud
8Leak CheckWARNING• Perform all leak tests outdoors.• Extinguish all open flames.• NEVER leak test when smoking.• Do not use the heater until all conn
Comentários a estes Manuais